I. Purpose: To make the warehouse manager understand the characteristics and structure of the all-electric stacker, and master the operation procedures, precautions, and daily maintenance of the all-electric stacker. Second, the operation method: the warehouse manager is familiar with the stacker must be on the open space, until the basic familiarity can be used on the first and second floor of the shelf, familiar with one month, before the operation of the third, fourth and fifth stack of goods . 1. Start the electric stacker: check to make sure the battery is fully charged and the indicator light is on. Insert the key into the electric lock, turn it clockwise, and lift the emergency stop switch to start the stacker. 2. Forward/reverse of the electric stacker: Move the control handle of the stacker to one side and swing it down to an appropriate angle. (Leaving the vertical position but not pressing to the lowest position), then use the thumb to turn the two knob switches: If you turn this switch forward, the stacker will advance. If you turn this switch backwards, the stacker will retreat. . The forward/reverse speed is controlled by the angle of rotation of the knob switch. When starting or when the surrounding space is small, in order to ensure safety, the rotation angle should be controlled to be small to slow down the driving speed. There is a low speed button on the handle and a low speed limit when pressed. 3. Lifting the fork of the stacker: Press the button with the rising mark on the control handle with your finger, then the fork will rise; press the button with the down mark to lower the fork; immediately release it. 4. Belly safety start: When the stacker retreats, if the body collides with the red belly switch, the stacker will stop immediately and move backwards in the forward direction for a short distance. This is mainly to prevent your body from being crushed. . 5, the general parking of the stacker: When you need the stacker to stop smoothly, release the thumb, the rotary switch will automatically reset, at this time through the controller to generate reverse current, the stacker will move a very small distance After a smooth stop. 6. Vehicle charging: When the power meter emits a flashing signal, that is, the "power is exhausted" alarm, it should be charged in time. When charging, first turn off the electric lock and pull the key out of the electric lock. Third, the operation steps load step: 1. Move the stacker to the front of the heavy object; 2. Raise the fork to an appropriate height below the bottom of the weight; 3. Move the stacker forward so that the fork extends below the weight; 4. Lift the fork until it is loaded with heavy objects; 5. The stacker moves back together with the heavy object until the fork has a drop space. 6. Slowly lower the weight to the appropriate height. Putting steps: 1. Move the stacker carrying heavy objects to the front of the shelf; 2. Lift heavy objects to an appropriate height; 3. Move the stacker to the appropriate position; 4. Slowly lower the weight so that the lower bottom of the weight tray falls on the shelf; 5. Slowly move the stacker and its fork out of the shelf. Adjusting Shims,Injector Adjustment Shim,Common Rail Injector Adjustment Shims,Injector Shims Shandong Iparts Trading Co., Ltd , https://www.cniparts.com